Avtech AVR-E3A-B, Instructions Manual

Page: 28 / 40

PROGRAMMING YOUR PULSE GENERATOR
KEY PROGRAMMING COMMANDS
The “Programming Manual for -B Instruments” describes in detail how to connect the
pulse generator to your computer, and the programming commands themselves. A
large number of commands are available; however, normally you will only need a few of
these. Here is a basic sample sequence of commands that might be sent to the
instrument after power-up:
*rst (resets the instrument)
trigger:source internal (selects internal triggering)
frequency 1000 Hz (sets the frequency to 1000 Hz)
pulse:width 50 ns (sets the pulse width to 50 ns)
pulse:delay 20 ns (sets the delay to 20 ns)
volt:ampl 50 (sets the amplitude to +50 V)
("-N" units should use "volt:ampl -50)
volt:low -2 (sets the DC offset, for units with the -OT option)
output on (turns on the output)
For triggering a single event, this sequence would be more appropriate:
*rst (resets the instrument)
trigger:source hold (turns off all triggering)
pulse:width 50 ns (sets the pulse width to 50 ns)
output on (turns on the output)
volt:ampl 50 (sets the amplitude to +50 V)
("-N" units should use "volt:ampl -50)
volt:low -2 (sets the DC offset, for units with the -OT option)
trigger:source immediate (generates a single non-repetitive trigger event)
trigger:source hold
(turns off all triggering)
output off (turns off the output)
To set the instrument to trigger from an external TTL signal applied to the rear-panel
TRIG connector, use:
*rst (resets the instrument)
trigger:source external (selects internal triggering)
pulse:width 50 ns (sets the pulse width to 50 ns)
pulse:delay 1 us (sets the delay to 1 us)
volt:ampl 50 (sets the amplitude to +50 V)
("-N" units should use "volt:ampl -50)
volt:low -2 (sets the DC offset, for units with the -OT option)
output on (turns on the output)
28