A 50 Ohm output impedance exists between the internal pulse generator circuit and the
output connector on the front panel of the instrument.
A monitor output (“MON”) is provided as well, for monitoring the internal pulse
waveform. It can be used to sense the voltage drop across the main output resistance,
thus providing a measure of the actual output current. However, the user of a dedicated
current transformer or current probe is normally recommended for current sensing.
The AVR-D3-B features front panel keyboard and adjust knob control of the output
pulse parameters along with a four line by 40-character backlit LCD display of the
output amplitude, pulse width, pulse repetition frequency, and delay. The instrument
includes memory to store up to four complete instrument setups. The operator may use
the front panel or the computer interface to store a complete “snapshot” of all key
instrument settings, and recall this setup at a later time.
The instrument is protected against overload conditions (such as short circuits) by an
automatic control circuit. An internal power supply monitor removes the power to the
output stage for five seconds if an average power overload exists. After that time, the
unit operates normally for one second, and if the overload condition persists, the power
is cut again. This cycle repeats until the overload is removed.
This instrument is intended for use in research, development, test and calibration
laboratories by qualified personnel.
6
Summary of Contents for AVR-D3-B
