5
1. CAMERA NETWORK CONFIGURATIONS
Please follow the instructions below to finish camera installation and network configurations.
You may configure the network connection of this network camera with your laptop / computer, or with your iPhone®
or iPad® based on your network environment.
1.1 Assemble & Install Camera
Step1: Fasten the base of the bracket (the round one) to where the camera is installed.
Step2: Assemble the bracket and the camera, and adjust the viewing angle of the camera.
Note:
The tilt angle of the camera is limited to 30 degrees, and the right/left pan angle is limited to 15
degrees each.
Step3: Connect the supplied power adapter to the camera’s power jack (DC 5V / 2A) on the rear panel and the power
outlet.
Step4: Continue to proceed network configurations as instructed in the following sections.
1.2 Understand How Your Laptop / Computer Connect to Internet
Then, connect your network camera directly to your wireless router / router / hub / modem with a network cable,
and power it on.
Note:
Check (LAN) status indicator is always on, not blinking. If it’s blinking, check your RJ45
network cable and ensure it’s not disconnected or defect.
