3
2. INSTALLATION & CONNECTION
2.1 Install the Hardware
This camera can be installed in two ways: ceiling-mounted and desktop. During the installation,
please make sure the upper side of the camera is always facing up, as shown in Figure 1 below
(Regardless of which installation way you’re using). This is to ensure the video output won’t be
up side down.
Note:
The illustrations below are based on the ceiling-mounted installation.
Note:
For the detailed cable connection, please refer to “1.3 Rear Panel” on Page 2.
Tool needed: Power drill x 1 (not supplied within the sales package)
Prepare all the parts needed for camera installation.
Find the network camera, bracket package, a bag of screws & wall plugs, and a cap supplied
with the sales package, as shown in Figure 1.
Unpack the bracket package to find the bracket disassembled into three parts: the base, stem
and joint lock.
Figure 1: Parts needed for camera installation
1. Fix the base of the bracket.
Fix the base of the bracket with the
supplied three screws to where the camera
will be installed by using a power drill.
Figure 2: Screw the base to the ceiling
