8 Channel DMX control
Channel
DMX
Function
1
0-255
Master dimmer
2
0-255
Red dimming
3
0-255
Green dimming
4
0-255
Blue dimming
5
0
Red, Green and Blue LED’s on
1-255
Colour change from slow to fast
6
0
Off
1-255
Colour flash from slow to fast
7
0-50
Manual mode. DMX Channels 1-6 available
51-100
Choose colour
101-150 7 colour gradual change from slow to fast
151-200 7 colour pulse change from slow to fast
201-250 7 colour jump change slow to fast
251-255 Sound mode
8
0-5
Laser off
6-49
Auto mode
50-99
Red laser on
100-149 Green laser on
150-199 Red and green laser on
200-255 Red and green laser change automatically
DMX address setting
When controlling the unit (or units) with a DMX controller, each one must be set with a specific DMX address. You can choose to set
all units with the same DMX address or you can set every unit with its own DMX address. If all units are set with the same DMX
address all units will be synchronised and operate in the same way, you cannot control each unit separately. If you set each unit with
a different DMX address, they will receive the DMX signal from their own DMX address. You will now be able to control each unit
individually. The DMX address that you set for each unit must be determined by the number of channels. This unit has 8 channels,
therefore you should set the starting address of the first unit to 1, the second unit must then be set to 9 (8+1), the third unit must be
set to 17 (9+8) and so on.
Troubleshooting
Problem
Check list
Troubleshooting
No output -
the unit does not
appear to work
1. Check if the power cord is connected to the input
mains socket of the unit.
1. Make sure there is mains present to the cable,
check the fuse or replace the cable.
Lights are
dimmed
1. Check if the power cord is connected to the input
mains socket of the unit.
1. Make sure the mains input voltage is the
correct voltage.
No DMX input
1. Check that the cable is not damaged.
2. Check the polarity of the pin connections is correct.
3. Check lf the unit is in DMX mode.
4. Check if 2 units are set as Master units in a chain.
1. Change the DMX cable.
2. Correct the DMX polarity or change the cable.
3. Set up the function mode as DMX.
4. Set all other units as Slave units in the chain.