Switching:
The AC-
CX62
-AUHD
can be switched from the front panel by
pressing
the
corresponding
OUTPUT
SELECT
button:
1.
Press the
HDBT OUTPUT SELECT
button
to cycle through the four Inputs
2.
Press the HDMI OUTPUT SELECT button to cycle through the four Inputs
3.
Press and hold the desired OUTPUT SELECT button (HDBT or HDMI) for 3 seconds to Enable/Disable
AUTO SWITCH MODE
(all INPUT LEDs will flash)
a.
AUTO SWITCH Enabled - AUTO LED ON
b.
AUTO SWITCH Disabled - AUTO LED OFF
Basic Installation:
Basic Control Using Front Panel:
1.
Plug in the display(s) or sink devices
2.
Plug in the sources
3.
Plug in the power supply to the AC-
CX62
-AUHD
4.
Power on the Sources and Display(s)
This will ensure proper EDID application across the device.
The unit has an Auto-Config on boot up and reception of new sources and displays to maximize plug
and play installation:
Auto-Switching Logic
When the AC-
CX62
-AUHD is in "Auto" mode the logic is to switch to the most recently plugged in device based on a Hot Plug
Event. You can have either the HDMI, HDBaseT, or both be set to "Auto" mode.
AC-CX62-AUHD
Page 6
