AVPro Edge ~ 2222 E 52
nd
ST N, Sioux Falls, SD, 57104 ~1.877.886.5112 ~ +1.605.274.6055 ~ [email protected]
16 of 29
Configure Page
NOTE
:
You must connect an MXNet Control Box, MXNet Encoders/Encoders, and MXNet Decoders/Decoders
to your network switch prior to attempting to input any information on the CONFIGURE pages. The
CONFIGURE pages will remain blank until that equipment is connected.
Inputs/Encoders/Sources
Looking at the page from left to right you will see the following columns:
NAME (AUTO)
: ( Example: Tx1, Tx2, Tx3, etc. ) This info is automatically generated by the MXNet control
system for keeping internal track of the connected Encoders. This field is grayed out, and cannot be edited.
CUSTOM NAME
: Assign any custom name to a Encoder. You have up to 12 characters available - no spaces.
DESCRIPTION
: Enter any text desired. You have up to 12 characters available - no spaces.
EDID MGMT
: Choose an EDID which will provide the highest level of compatibility with the target display. In
most cases, a generic lower common denominator EDID such an 1080P 2CH will provide the best
CHANNEL
: Each channel number must be unique. The MXNet control system will automatically assign
channel numbers to each Encoder. If you notice a duplicate channel number ( highly unlikely ), then assign a
unique number. You have 9,998 possible combinations.
IP ADDRESS (AUTO)
: The IP Address is automatically generated by the MXNet control system. This field is
grayed out, and cannot be edited.
MAC ADDRESS
: The MAC Address is pre-assigned to each Encoder. This field is grayed out, and cannot be
edited.
Encoder LIGHTS
: Encoder lighting controls ( mini-display, PWR, LINK, and Network link/activity ) are actuated
using rotating toggle/clicks: Click once to cause all lights on the Encoder to FLASH, click again to Turn OFF all
lights, and click once more to Turn ON all lights. You have the option to actuate this feature with individual
Encoders or ALL Encoders.