STEP 1:
Press and hold the desired extracted
audio output you want to delay
STEP 2:
Choose the delay
setting
The LCD Screen
shows current
status
pg.
9
AVProEdge ~ 2222 E 52nd St N Sioux Falls, SD 57104~ 1.877.886.5112 ~ +1.605.274.6055 ~
support@
avproedge
.com
AC-MX44
/88
-AUHD-HDBT
Audio Delay Control:
The AC-MX88/44-AUHD has an Audio Delay feature built-in. Audio Delay is set on the extracted
audio OUTPUT (Digital and Analog) of the switch and each can have separate settings. The Audio
Delay has 4 controls:
•
UP (Increase Delay)
•
Down (Decrease Delay)
•
MUTE (The audio will be muted)
•
BYPASS (There will be no delay
set)
*Delay settings are in increments of 90 milliseconds. Settings are: 90MS, 180MS,
270MS, 360MS,
450MS, 540MS or 630MS.
Control this feature from the front panel:
1.
Press and hold the OUTPUT number for which you want to delay the
audio.
2.
The available options will light up (as pictured).
3.
Press UP, DOWN, MUTE or BYPASS to control the delay.
4.
The current setting will be indicated on the LCD screen.
Audio Output Logic and Cable Prep:
You can extract audio from toslink or balance 2CH Audio. Audio outputs are an un-decoded
output. This means that what goes in, is what goes out.
2CH Balanced Audio Port - Supports 2CH PCM audio only, which is ideal for 2 Channel systems and
zoned audio systems. No Down-mixing see AC-ADM-AUHD or AC-ADM-COTO
Toslink Audio Port - Supports PCM, LPCM (up to 7CH), Dolby Digital, Dolby Digital Plus, DTS, DTS-
HD, DTS Master Audio, which is ideal for multi-channel audio systems and older AVR's that do not
support 18Gbps.
Need to down-mix for combination, uncompressed and 2CH systems? Check out the AC-ADM-
AUHD and AC-ADM-COTO.
You can use balanced analog outputs in a balanced system, but you can also prep a cable as
shown below to convert to a traditional 2CH unbalanced (L/R) system. You can also purchase pre-
made cables (AC-CABLE-5PIN-2CH) at www.
