■
The
Receiver
Back
Front
HDBaseT
PoE Setting
RS232
L/R Out
(PCM Only)
HDMI
Out
Micro USB
(Firmware)
IR Out IR In
Indicator Troubleshooting Lights on the Receiver:
POWER - On the back by the power supply input:
(Red)
This indicator shows that the power is connected.
There are only two states for light:
•
Light Is On = Power supply is connected and functioning
•
Light Is Off = Power supply is not connected or no power present. - (In order to have power try checking
the power supply, USP, Outlet, etc...).
*LED flashes when using the settings button described below.
STATUS - On the front by HDMI port:
(Blue)
This indicator shows that the HDMI Display, Projector or sink
is connected. The states are:
•
Light Is On (Solid) = Sync w/ HDMI source is valid and solid.
•
Light Is Flashing = The light flashes during the sync process. If it is flashing continuously, you may still
have a picture, but it is indicating that the Rx is correcting a BE (Bit Error) to make the picture show on
the display.
Things to check if
BLUE HDMI STATUS LIGHT
is flashing AND you have no picture:
1.
The display to make sure it is working properly (plug source or generator into display directly).
2.
Try a different HDMI Input - Some have different functions/capabilities per display.
3.
Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths.
4.
If these suggestions do not work, enable the "Test Pattern" (See Below). If you see the pattern, the
problem is before the Rx, please try a different source or EDID on the Tx. You can also try to scale the TX to
1080P (see transmitter functions above).
5.
Contact AVProEdge if these steps do not work.
AC-EX40-444-KIT
Page 9