(The technical characteristics are liable to change without notice)
Power supply
Dimensions of unit
Weight
Frequency range
Output power
Speaker
Headphones
Suggesting USB Capacity
: DC 9V (AC adaptor),100-240V 50/60Hz
: 250(L) x 110(W) x 95(H) mm
: 0.518kg
: FM 88 to 108MHz
: 2 x 2.5W
: 8 Ohms
: ø 3.5mm
: Support Version 1.1 (Fat format)
≤
1G Memory Stick
Troubleshooting
If a problem occurs, check the points below before taking the apparatus in for repair.
If you are unable to remedy a problem by following these hints, contact your dealer or after-sales service
center.
WARNING:
Under no circumstances should you attempt to repair the set yourself; as this will invalidate the
guarantee. Do not open the set as there are a risk of electric shock.
No sound
Volume not adjusted.
→
Adjust the volume.
The set is muted.
→
Press “MUTE” on the remote control to active playback sound.
Display error / no reaction to any controls
Electrical malfunction.
→
Unplug the AC adaptor, then re-plug;
→
Remove backup batteries;
→
wait 1 hour then resume use.
Intermittent crackling sound during FM reception
Weak signal.
→
Extend and position the FM pigtail aerial.
The alarm does not function
Alarm time / mode not set.
→
Please refer to Setting the Alarm.
Volume too low for radio.
→
Increase the volume.
iPod does not dock properly
Using no or wrong iPod insert.
→ Make sure the dock insert is the proper fit for your iPod.
iPod didn’t install properly.
→ Remove your iPod from the dock and check for obstruction on the connectors in the dock and on your iPod.
iPod does not response to the unit/iPod is playing but no sound comes out
iPod is not installed properly.
→
Remove your iPod from the dock and check for obstruction on the connectors in the dock and on your iPod. Then reseat
it in the dock.
iPod is locked up/plays but no sound comes out.
→
Check your volume setting. Make sure your iPod is working properly before docking into the unit. Please refer to your
iPod manual for details. See above for upgrade information. You may need to reset your iPod. To do so:
1. Toggie the Hold switch to hold position, then off.
2. Press and hold the Menu and center Select buttons at the same time until Apple logo appears. You may need to repeat
this step.
Unit/iPod performance is erratic
The unit is reacting to external interference.
→ Move unit away from potential sources of external interference such as computers, modems, wireless devices (routers)
or fluorescent light.
iPod didn’t charge up
iPod is not installed properly.
→
Remove your iPod from the dock and check for obstruction on the connectors in the dock and on your iPod. Then reseat
it in the dock.
iPod is locked up/frozen or iPod battery has problem.
→
Please make sure your iPod is working properly before docking into the unit. Please refer to your iPod manual for
details.
Remote Control didn’t work
Battery weak.
→
Replace current battery with new battery.
Remote Control is not pointed toward the unit remote sensor.
→
Point the Remote Control toward the unit remote sensor (to right of display), move within 10 feet of the unit.
Unit/adaptor gets warm after extended play at high volume
This is normal.
→ Turn unit off for awhile or lower volume.
Maintenance & Safety
Install the unit near the AC outlet and where the AC adaptor can be easily reached.
The apparatus shall not be exposed to dripping or splashing,
Do not expose the set to humidity, rain, sand or excessive heat caused by heating equipment or direct
sunlight.
To clean your set, use a damp cloth or chamois leather. Do not use cleaning products, which contain
benzene, thinner, etc. As these may harm the housing.
Specifications
ENG-9
ENG-8
