AVOCOR AVF-7550, Installation And Operation Manual

Page: 67 / 77

Revision Date: 2018/07/25 67
Appendix III: Installing an OPS Module
Follow the steps below to install an OPS module.
Step 1 Ensure that the display is turned off (power socket on rear of display).
Step 2 Use a screw driver to unscrew the OPS slot cover on the display input panel. Do not lose the
screws (M4*6) that are removed.
Step 3 Install the OPS module by sliding it gently into the OPS slot until you hear a click, indicating
the module is securely inserted. When using an Avocor OPS PC, the fan should be facing to
the backside of the display. Do not apply by force.
Step 4 Secure the OPS module in position, by screwing it onto the display input panel using the
screws (M4*6) that were removed earlier.
Step 5 Turn on the interactive display. When using an Avocor OPS PC a green light on the side of the
OPS PC should appear, indicating that the OPS PC is switched on and operational.
NOTE • When installing or uninstalling an OPS PC, the display must be switched off. If the display is
on when performing the installation or uninstallation of the OPS PC, this could cause
damage to either the display or OPS PC invalidating the warranty for both.
• The right bottom handle can be unscrewed for OPS module installation. Please reinstall
the handle after inserting the OPS module.
Use maximum 6mm/0.24” long screws.
4mm/0.16” Metric