Avocet AV-100, Operating Manual

Page: 14 / 18

AVOCET AV-100
4
rear panel (see figure 2, page 1). The level range is
approximately +10 to -10 dBm.
Main-Out Same as SAP-Out, but carries Main channel audio.
Adjust These two controls adjust the output level of the rear panel
SAP and Main outputs.
Internal Controls
:
Channel Selector Channel selection is made from an eight-position dip
switch located on the receiver circuit board. Channels are
assigned as follows:
0=Switch Closed (ON), 1= Switch Open (OFF)
Table 1 - Channel Selector Codes
Ch 12345678 Ch 12345678 Ch 12345678
24 00011000 47 11110100
2 01000000 25 10011000 48 00001100
3 11000000 26 01011000 49 10001100
4 00100000 27 11011000 50 01001100
5 10100000 28 00111000 51 11001100
6 01100000 29 10111000 52 00101100
7 11100000 30 01111000 53 10101100
8 00010000 31 11111000 54 01101100
9 10010000 32 00000100 55 11101100
10 01010000 33 10000100 56 00011100
11 11010000 34 01000100 57 10011100
12 00110000 35 11000100 58 01011100
13 10110000 36 00100100 59 11011100
14 01110000 37 10100100 60 00111100
15 11110000 38 01100100 61 10111100
16 00001000 39 11100100 62 01111100
17 10001000 40 00010100 63 11111100
18 01001000 41 10010100 64 00000010
19 11001000 42 01010100 65 10000010
20 00101000 43 11010100 66 01000010
21 10101000 44 00110100 67 11000010
22 01101000 45 10110100 68 00100010
23 11101000 46 01110100 69 10100010
Figure 5 - Channel selector switch set for channel 5
Off
On
1 2 3 4 5 6 7 8