Avocent AV Works, Installer/User Manual

Page: 94 / 144

82 AVWorks Installer/User Guide
3. If this is the first time the appliance has been accessed since its initialization, or if credentials
are not cached for the appliance, a username and password prompt displays. (See Managing
Cached Credentials on page 17 for information about credential caching.)
a. Type in your username and password. [If this is the first appliance access since initializa-
tion or reinitialization, the default username is
Admin
(case sensitive) with no password.]
b. Click OK .
-or-
Click
Cancel to exit without logging in.
The CCM AMP appears.
To exit the AMP:
Click OK to save any changes and exit the AMP.
-or-
Click
Cancel to exit the AMP without saving any changes.
Viewing Global General Settings
The Global General category displays the appliance’s product type and serial number (EID). This
information cannot be modified.
Viewing and Changing Global Network Settings
The Global - Network subcategory specifies the appliance’s IP address, subnet mask, gateway and
MAC address (read-only). The appliance name is also displayed. The name is read-only in this sub-
category; you may change the appliance name in the SNMP category.
To change global network values:
1. Click the Settings tab in the CCM AMP.
2. Select the Global - Network subcategory.
3. In the IP Address field, enter the appliance’s address in IP dot notation. The value cannot be a
loopback address or all zeros.
4. In the Subnet Mask field, enter the appliance’s subnet mask in IP address dot notation. The
value cannot be a loopback address or all zeros.
5. In the Gateway field, enter the appliance’s gateway address in IP address dot notation. The
value cannot be a loopback address. If there is no gateway address, enter
0.0.0.0
.
6. Click Apply to save any changes without exiting the AMP.
-or-
Click
OK to save any changes and exit the AMP.
-or-
Click
Cancel to exit the AMP without saving any changes.