10 Getting Started with the CC3000-Pmod
™
Compatible Wi-Fi
®
Adapter
Version 1.0
The results should look as follows:
Figure 1
2. Connect LX9 MicroBoard’s P1 USB connector on the LX9 board by plugging in to an available USB
port on the computer
3. From a DOS command prompt window, go to the directory where the files have been extracted to and
execute the provided .bat file to commence
sfutil.exe
re-programming of LX9 board’s N25Q128 serial
flash (only the first 4MB erased/programmed) with the
MM_DROP_073112.mcs
Xilinx configuration file.
The results should be as shown in the following two DOS windows.
4. Once completed, remove the LX9 MicroBoard from the computer’s USB Port
Figure 2
Figure 3
The IP parameters shown in the DOS window above have been hard-coded in the project’s
demo_config.h
and
cc3000.c
files. Thus the Wireless Access Point/Router configuration must be edited accordingly on your WAP:
Access Point/Router SSID =
xfest2012-s6lx9
AP LAN subnet IP address =
192.168.1.1
