AVM INSPIRATION CS 2.2, Operating Instructions Manual

Page: 7 / 27

7
15
Antenna socket
16 Ground socket for turntable chassis
17 Network port (LAN)
18 Phono input
19 High-level analogue inputs
20 Status LED
21 Update button (Streaming module)
22 Reset button (Streaming module)
23 USB input
24 WiFi antenna socket
25 Output for recorder (fixed level)
26 Preamplifier output
27 Configuration port
28 Speaker terminals
29 Digital input coaxial
30 Digital input optical
31 Digital output coaxial
32 Digital output optical
33 Mains switch
34 Mains connector
1.3 Installation and cooling
The unit can become hot depending on demanded output power or environmental
temperature. Therefore, it is important, that the cooling air can flow unhindered into the air
inlet in the bottom and flow out through the holes in the rear panel. Direct exposure to
sunlight is not recommended because this will heat up the unit and may cause unwanted
malfuctions.
1.4 Connection to mains
Connect the unit to the mains outlet by using the power cord which is (in some countries)
delivered together with the unit. Make sure that mains voltage is according to the value
printed on the rear panel of the amp (near mains connector).
CAUTION:
Keep the unit switched off until all audio connections are made.
1.5 Connecting analogue signal sources
High-level sources
Connect the outputs of your signal sources to the inputs (19). The upper row is for left
channel, the lower row is for right channel.