
Configuring the ISDN-Controller B1 v3.0
ISDN-Controller B1 v3.0 – 8 Installation in Windows 3.x
51
8.2 Configuring the ISDN-Controller
B1 v3.0
To configure the controller with a new I/O address, proceed
as follows:
1.
Start the “B1 Setup” program by double-clicking on the
corresponding icon in the “AVM” program group.
The following window is opened:
Dialog of the “B1 Setup” program
2.
Enter new values for the I/O address and the interrupt
here.
The interrupts 10, 11, 12 and 15 can be used only if the
ISDN-Controller was inserted in a 16-bit slot.
3.
Save your entries by clicking “OK”. The values specified
for the ISDN-Controller are registered in the SYSTEM.INI
(Windows directory) and ISDNLOAD.CFG (directory of
the driver software) files.
4.
Restart Windows to implement the changes.
Note that when multiple AVM ISDN-Controllers are used, the
“B1 Setup” program changes only the configuration of the
first ISDN-Controller. Changes to the I/O address and inter-
rupts of all other ISDN-Controllers must be made manually in
the SYSTEM.INI and the ISDNLOAD.CFG files.
HB_B1V30.book Seite 51 Mittwoch, 7. Februar 2001 3:19 15