Latest products and information available at www.avlite.com
11
AV-SAL-01
Solar Area Light
Assembly
Before installing the area light, please read the section on wind loading and ensure that the installation
will be suitable.
Before installing the foundations, please consider the layout of the light arm location, solar panel
direction required and the mounting foot print of the battery housing.
Ensure that the prepared foundations are suitable to withstand the wind loading and comply with local
laws.
Bolt the area light pole to the battery housing. Too stop water from entering the battery box, place a thick
bead of silicone around the mounting flange of the area light pole and the bolt holes during assembly.
Fit the pole up to the battery housing and fix together using the 3 x M16 x 75 bolts. Tighten the three
mounting bolts to 200nm.
Fit the solar array on to the top of the light pole. Feed the solar cable down through the centre of the
area light pole and into the battery housing. This will need to be done during the installation of the solar
array. Tighten the M10 locking screws, to fix the solar array into place.
Fit the light head to the light arm if not already fitted, using the 4 x M6 x 25 hex head bolts. Feed the
head of the bolt into the mounting channel on the base of the area light head. Locate the 4 bolts through
the mounting plates on the area light arm and fix into place with the 4 x M6 washers and M6 Nylock nuts.
Feed the light cable into and through the light arm. Position the light arm up to it’s mounting location
on the area light pole and continue to feed the cable into the area light pole and down into the battery
housing.
Fit the light arm into location and fix into place with a M6 x 65mm hex head bolt, M6 washers and M6
Nylock nut.
Using suitable lifting equipment, install the area light on to its foundation and fix into place.
To complete the installation, follow the directions in the ‘Regulator Connection & Operation’ section of
this manual.
