Latest products and information available at www.avlite.com
9
Universal AC Low Intensity Obstruction Light
Dual Light Fixture
Safety Information
• Install the light in compliance with the effective local electrical code(s).
• Mains power should always be disconnected when work is being done in close proximity to
electrical fittings, and electrical work should only be done by a licensed and certified professional.
• Operate the light only within the indicated electrical ratings and product usage instructions.
• To ensure that the light and peripheral equipment function safely and correctly, use cable in
compliance with the effective local electrical code.
• Do not stare at the LED or shine the LED into your eyes or those of another person.
• Do dispose of the product according to the local laws and regulations for your region, for example,
at a recycling center that accepts electronic devices.
Unpacking, Mounting, Installation, Wiring & Setup
Unpack all hardware and inspect for damage. If there is any damage, please contact your Avlite Office.
Retain original packing material for possible future use in shipping.
Unpacking
Mounting
Mount the Obstruction Light using its four mounting holes. Make sure the light is horizontally aligned to
guarantee the required beam pattern of the obstruction light.
Installation & Wiring
Before proceeding with installation or service, make sure the following conditions are met:
• Ensure the tower or mast is grounded (No RF HAZARD)
• Check the mast lighting circuit is not faulty
• Ensure power lines are not ‘live’ (NO ELECTRICAL HAZARD)
• Avoid touching live circuits!
• Avoid touching any component or any part of the circuitry while the unit is operating. Do not change
components or make adjustments inside the unit with power on.
NOTE:
The unit must be installed by a qualified and certified professional.
OPENING AND CLOSING THE LIGHT HEAD(S)
Remove the locking screw
In order to open the unit, the top half of the unit should be turned anti-clockwise with respect to the
bottom half. The top half will turn approximately 20mm over a positive “click” before separating from
the bottom half. Attention should be paid to the restriction caused by the internal cabling which is
secured by a cable gland.
