Add casters to a K-series Loom
Updated: June 8, 2021
Page | 2
2)
Use the rear casters diagram to determine where the holes should
be drilled on the rear legs. Mark the position of the hole on the
loom.
Figure 2 - Drill diagram for rear legs
3)
Drill thru the frame at the marked holes using a size H (.266”)
diameter bit.
Attach Casters
One of the available options for the K-series loom is wheeled casters which
allow the loom to be easily moved from one location to another. When the
loom is not being moved, the casters are securely locked into position.
Note:
The casters at the front of the loom are positioned at the sides. The casters at
the rear of the loom face the back.
1)
Find the four casters and the hardware. There are four long bolts
and four short ones. The short bolts are used on the front of the
loom and the long bolts are used at the rear.
2)
Place a caster on the front leg of the loom against the drilled holes
on the side frames, with the bracket facing up. Place the short bolts
through the holes in the caster and the loom from the inside of the
loom.
3)
Secure each bolt with a nut.
4)
Repeat for the other front leg.
