Avital AviStart 6000, Installation Manual

Page: 12 / 28

Remote Start Activated (-) Output
The GRAY/BLACK wire will provide a continual ground output for as long as
the vehicle is in the remote start mode. This output can be used for additional
ignition, starter or heater/AC relays, VATS, Passlok and Passkey bypass.
Factory Alarm Disarm (-) Output
The GRAY/WHITE wire will provide a 0.75 second ground output when the
START button is pressed.
1. Arm the vehicle factory alarm system.
2. Use a volt/ohmmeter to locate the one wire that will show ground only
when the driver door key cylinder is held in the unlock position.
NOTE: most factory alarm/disarm wires will show 8-12 volts while
armed. A few vehicle disarm wires will rest at a neutral state while
armed. Regardless of type, both types will change to ground when the
key cylinder is turned to unlock.
3. Connect the GRAY/WHITE wire to the factory alarm disarm wire.
Accessory Remote Start (-) Input
The BLUE/ORANGE wire will accept a (-) input pulse to activate the
remote start.
Trunk Switch
1. Locate the vehicle trunk switch that shows ground when the trunk is
open only.
2. Connect the alarm module TAN/BLACK wire to the vehicle trunk switch
wire.
3. If the vehicle does not have a trunk switch, install a pin switch and
connect it to the alarm module TAN/BLACK wire.
Ignition Switch Connections
NOTE: Because these wires can draw high current, we recommend that they
be soldered and shrink tubed or taped. If only one 14 ga PINK wire is
needed, tape the end of the second 14 ga PINK wire to prevent a short
circuit The alarm module has an 18 ga PINK wire that must be connected
with one of the satellite module 14 ga PINK wires that is connected to the
vehicle ignition wire.
10
AviStart 6000 Installation Manual