Avital AVISTART 4000, Installation Manual

Page: 9 / 24

Parking Lights
1. If the parking lights are positive trigger, connect the RED/WHITE
wire to
the battery positive (+) terminal through the 20 amp fuse assembly.
NOTE: Do not connect the RED/WHITE wire to the control unit
RED wire.
2. If the parking lights are negative (-) trigger, connect the RED/WHITE wire
to control unit BLACK wire.
3. Connect the
RED/BLACK wire to the vehicle parking light wire.
Reverse Light
I
CAUTION : Some vehicles allow you to remove the gear shift
selector from "Park" even while the ignition key is not on. As a safety
feature, the system will monitor the reverse wire. If the vehicle is
removed from "Park" while in the remote start mode, the system will
shut down immediately.
1. Set the parking brake.
2. Turn the ignition key to the "ON" position and adjust the gear shift
selector to "Reverse."
3. Use a voltmeter to find the wire that will show +12 volts in "Reverse" and
0 volts in "Park."
4. Connect the YELLOW/BLACK wire to the vehicle’s reverse light wire.
Interior Light Illumination Output
1. Connect the alarm WHITE/BLACK wire to relay terminal 85.
2. Connect relay terminal 86 to a fused co12 volt source.
3. Connect relay terminal 30 to the vehicle door trigger wire(s).
4. If the vehicle door trigger is positive (+) trigger, connect relay terminal 87
to a fused +12 volt source.
5. If the vehicle door trigger is negative (-) trigger, connect relay terminal 87
to ground (-).
7
AviStart 4000 Installation Manual - 8/98 Rev. B