Two Pulse Un lock
Some vehicles require two pulses to unlock the doors. The alarm can be
programmed to pulse the unlock wire two times when the alarm is remotely
disarmed. (See "Programming Alarm System Features" on page 12.)
Door Lock/Un lock Out puts
The alarm provides a .75 second 300 MA (-) output for lock and unlock.
Follow the door lock diagrams on pages 9 - 11.
Hood/Trunk Pin Switch
1. Locate the vehicle hood or trunk pin switch that shows ground when
the hood or trunk is open only.
2. Connect the alarm module TAN wire to the vehicle hood or trunk
switch wire.
3. If the vehicle does not have a hood or trunk switch, install a pin switch
and connect it to the alarm module TAN wire.
Si ren
1. Choose a location in the engine compartment away from high heat
engine components, moving parts and direct exposure to water.
2. Make sure the siren and siren wires cannot be seen or reached from
below the vehicle.
3. Mount the siren with the two self tapping screws to a solid metal
surface.
4. Connect the siren BLACK wire to the alarm module VIOLET wire.
5. Connect the siren RED wire to the alarm module RED wire.
Power and Ground Con nec tions
Caution: Do not plug in the system fuses until the final step below.
1. Connect the alarm RED wire to one of the supplied fuse assemblies.
2. Connect the alarm RED/WHITE wire to the other fuse assembly (if the
vehicle parking lights are (+) positive).
3. Connect the fuse assembly(s) to one of the supplied 10mm ring
terminals.
Con tin ued . . .
9
Diablo
2
/AMX 68/AT-58 Installation Manual 3/31/99
