Setting up Your Machine
2-6
Setting up the ADF (auto document feeder)
1.
As shown in the figure below, lift the document cover to remove the
studs from the hinge holes. The studs are loosely attached to the
hinge holes in the purpose to cover your original when it is a few
inches high.
2.
Insert the studs of the ADF cover to the hinge holes on the document
glass.
3.
Raise the ADF Tray to about 45 degrees.
4.
Pull down the wire leg beneath the ADF Tray.
5.
Pull out the ADF Tray extension to its full length.
ADF Wire Legs
ADF Tray
Extension
ADF Tray
Stud
Document
Cover