9
SW1
Function
Description
1
Signal tester
Inbuilt signal tester
Default OFF
2
Not used
Not used
3
Reserved
Avire internal use only
Default OFF
4
CAN
Ω
Activates the CANBus End of Line (EOL) for the CAN connector.
Default ON – DCP is typically an End of Line device.
SW1
Function
Description
1
Shaft (car)
number
Default OFF, OFF – DAU always in shaft 1 as part of the DCP.
(Function not necessary for DCP WAVE, leave as default)
2
Not used
Not used
3
CAN
Ω
Activates the CANBus End of Line (EOL) for the CAN connector.
Default ON – DAU is always the End of Line device.
Advanced Configurations
DCP Configurations: Dipswitch (SW1)
DAU Configurations: Dipswitch (17)
Additional Information for Programming the DCP
ADDITIONAL INFORMATION FOR PROGRAMMING THE DCP
+
All DCP parameters can be remotely configured via SMS sent to the SIM card’s number.
+
Each SMS message should begin with ‘Pin1234’ which is the access code to read or make any changes to the
configuration of the DCP.
+
You can modify or check several parameters in each SMS by separating them with commas ","
To send parameter information:
Text
Description
Pin1234, Pzzz xxx
(send)
•
Pin1234 is default PIN code for DCP
•
Pzzz is the programming command
•
xxx is the parameter
To read parameter information:
Text
Description
PinXXXX, Pzzz?
(send)
•
Pin1234 is default PIN code for DCP
•
Pzzz is the programming command
•
“?” is to request a parameter read