7
IR REMOTE CONTROLLER
POWER
Under normal working mode, press POWER to enter standby
mode. Press POWER again, camera will start self-initialization, then go
back to HOME position.
It will go to preset position 0 if the preset is set.
FREEZE
(
do NOT support USB output
)
Press FREEZE to freeze/ unfreeze the image.
IRT (IR Transfer/IR Pass)
Enable/ disable the IR pass function. Press IRT, camera will
receive and pass the IR remote control signal to the codec/terminal (via
VISCA IN port). Press IRT again to disable the function.
SET 1~SET4 ADDRESS SETTING
To set the current camera’s address (ID), press and hold the key
for 3 seconds until the backlight of the key is lighting up.
CAM 1~CAM 4
(
CAMERA SELECTING
)
Press the corresponding camera number to select the camera.
NUMERIC KEY (1-9)
Set preset: press and hold the number for 3 seconds to set preset
position.
Call preset: press the corresponding number to call preset position.
CLR PRE (CLEAR PRESET)
Press
【
CLR PRE + number
】
to clear the corresponding preset
position. Press and hold CLR PRE to clear all existing preset positions.