Installing the 10G Base-T Card in Slot 4 of Expansion Riser
With the NVR5 open:
1. Unpack the 10G Base-T card.
2. If expansion boards with internal cabling are installed on the PCI riser cage, disconnect all internal
cables from the expansion boards to remove the cage from the server.
3. Remove the PCI riser cage.
4. Install the 10G Base-T card in slot 4 of the expansion riser:
a. Slide the card into the slot guide opposite the connector to align the connector on the card with
the connector on the riser.
b. Insert the card edge connector firmly into the expansion card connector until the card is fully
seated.
c. After the card is installed, close the expansion card latch.
5. Reinstall the PCI riser cage back into the NVR5 and reconnect any internal cables from the expansion
boards.
Installing the 10G Base-T Card in Slot 4 of Expansion Riser
7
