•
PLACE THE TURNTABLE WHERE IT IS TO BE PLAYED - THIS SHOULD
BE A FLAT LEVEL RIGID SURFACE.
•
PLACE THE MOTOR CLOSE TO THE SUBCHASSIS AS IN PICTURE.
•
MAKE SURE THE MOTOR DOES NOT TOUCH THE CHASSIS.
•
IDEAL POSITION IS 118mm FROM SPINDLES CENTRE TO CENTRE.
ALWAYS USE CLEAN HANDS TO AVOID CONTAMINATING THE BELT.
•
PLACING THE PLATTER UPSIDE DOWN, FIT THE BELT FITTING PIN
INTO THE HOLE ON THE EDGE RIM OF THE PLATTER.
•
FIT THE FIRST BELT TO THE INNER HUB AND THEN ONTO THE
FITTING PIN, FOLLOWED BY THE SECOND BELT.
•
TAKE CARE NOT TO GET ANY DIRT OR GREASE ONTO THE BELT.
•
PLACE THE PLATTER ONTO THE BEARING - DO NOT DROP INTO
PLACE AS THIS MAY CAUSE DAMAGE TO THE SAPPHIRE.
•
TRY TO POSITION THE DRIVE PULLEY SO THE BELTS ARE EITHER SIDE.
•
ROTATE THE PLATTER MAKING SURE THE BELTS FIT ONTO THE DRIVE
PULLEY CORRECTLY AND THEN REMOVE FITTING PIN.
•
THE DRIVE BELTS SHOULD BE POSITIONED AS IN THE IMAGE BELOW.
•
CONNECT THE DIN LEAD TO THE REAR OF THE POWER SUPPLY.
•
CONNECT THE MAINS LEAD TO THE POWER SUPPLY.
•
FIT THE CLAMP BY SCREWING ONTO THE SPINDLE. MAKE SURE NOT
TO CROSS THREAD.
AFTER INITIAL ASSEMBLEY IT IS RECOMMENDED YOU RUN THE
TURNTABLE FOR ABOUT 3 HOURS TO CORRECTLY LUBRICATE THE
MAIN BEARING.
POWER SUPPLY
Front Panel: Power knob: rotate clockwise to switch on. Buttons PLAY/SPEED and indicator LED’s.
Rear Panel: IEC Mains socket; DIN output socket connection for motor lead.
The mains cable provided or a suitable alternative should be fused at no more than 5 AMPS.
To start the turntable, press ‘PLAY’. Default speed is 33 RPM and the play light will shine red.
To change speed the turntable power supply must be in the stop setting (not playing), however the
platter does not have to be stationary, so changing from 33 to 45 for instance, press the play button,
then the speed change button and then press play again and the platter will speed up to 45.
You may also start the turntable from stationary to speed up to 45 RPM.
To adjust the speed you’ll require a strobe disc or other method. One is not provided as there are
many commercially available and customers will have their preference of type and brand.
With the unit in PLAY mode and the desired speed selected, press both PLAY and SPEED buttons
together and hold until the speed light flashes.
Then press the left button to decrease speed and the right button to increase speed.
Then press both buttons together again to lock the speed.
Do the same for either speed and the setting is retained even after switching off the unit.
DO NOT SEE HOW FAST OR HOW SLOW THE UNIT WILL OPPERATE AS THIS COULD CAUSE
THE UNIT THE MALFUNCTION AND WILL NOT BE COVERED BY OUR WARRANTY.
Fuse in turntable PSU
PSU
220~250v T1.0A slow blow
100~120v T2.0A slow blow
DIVA II SP PSU FRONT
DIVA II SP PSU REAR
