Replacing the MTS
10
Connect and Install the New MTS
Your replacement MTS includes new Backlight and Touch-controller cables pre-installed. These cables connect to the GPIO and
SBC boards, respectively. Your existing LVDS cable is connected to the new MTS.
To connect and install the new MTS:
1
Carefully remove the new MTS from its packaging and set it on your padded surface on top of the console (orient and place it
the same as when you removed the old MTS).
2
Connect the Backlight cable (7070-30576-00) to its port (J12) on the GPIO board.
3
Connect the Touch-controller cable (7070-30616-01) to its port on the SBC, as appropriate for your model SBC:
4
Connect the LVDS cable to its port on the new MTS (
3
in Figure 12).
5
Use a 9/32 nut driver to replace the screws that secure each cable to the MTS.
6
Confirm Installation
To confirm a successful installation:
1
Being careful to keep cables from getting bent or pinched, place the new MTS into its slot in the control surface chassis. Do not
secure it yet.
2
Power on the S6L control surface and E6L engine.
3
Check that the MTS operates and that the system boots up as normal.
4
When you have confirmed a successful installation, proceed to
Backlight Cable Ports
SBC Type
SBC Port
Portwell USB2_9
(Right)
Congatec
Port X16 (Lower)
Emerson Port
P24L
After confirming that all MTS cables are fully seated and connected properly, apply a small amount of hot glue to each connector
to secure the cable in place.
