35
c
Do not set the SCSI ID for any drive on any SCSI bus to SCSI ID 7.
This SCSI ID is reserved for the SCSI accelerator board to which the
drive is attached. Setting a drive to the same SCSI ID as the SCSI
accelerator board can prevent the drive from mounting on the
desktop, or prevent your Avid system from booting correctly.
Avid recommends that you set the SCSI IDs for the devices on each
SCSI bus in sequential order, that is, starting with the device attached
closest to the Avid system as ID 0 (see
Figure 2-6
Setting SCSI IDs
SCSI IDs on Systems
You must assign a SCSI ID for each LVD shuttle in the MediaDock 2+
enclosure. When you are setting the SCSI IDs, remember the
following:
•
Each Avid PCI-based SCSI bus has its own set of unique SCSI IDs
from 0 through 6 and 8 through 15.
•
You cannot have two SCSI drives with the same SCSI ID on the
same SCSI bus.
ID 7
SCSI accelerator
Avid editing system
SCSI drives
Terminator
SCSI cables
ID 0
ID 1
ID 2
ID 3
board
