6.3 Installing the product into the Cradle
1. Insert SD memory card to the product
2. Hold product so camera part is at the
bottom and then slide it into the cradle from top to
bottom until it makes a clicking sound
3. Connect the power cable from product to cigar
jack of your vehicle. Then organize the lines using
li
li
1
2
3
6. Installation
line clips
4. Adjust the camera angle to your preference
[TIP] Use TV-out cable to connect to nearest display
to check the actual recording view and
make sure hood and dashboard does not show over
¼ of video’s bottom screen
RUBY Products :
5. Remove the tape cover
6. Attach IR lighting facing the same direction as Rear
Camera
[NOTE] If direction of the Rear Camera and IR Lighting
does not align, Rear Camera recordings might not record
correctly Please note vibrations and humidity of the
4
5
6
11
6.4 Confirmation
correctly. Please note vibrations and humidity of the
vehicle might detach the IR Lighting
1. Check to see that the SD card is correctly placed into the device and power switch is on
2. Start the car engine and check power is correctly connected to the device
3. Check Red LED is on following with Blue and Orange LED blinks.
4. Listen for a beep sound of 1CH products, 2 beeps for 2CH products and Orange LED to
stop blinking (booting complete, recording starts).
5. GPS connection can be confirmed as follows:.
If Blue LED blinks on and off, GPS reception is not complete and still in search
If Blue LED does not blink and stays on, GPS reception has been made
