AVG-UHMS44PRO
5.2.2. IR Carrier Forcing
a)
Only if the IR receiver connected to HDBaseT receiver is with IR carrier, can the
received IR signal be transferred to IR OUT port of the matrix.
b)
Only if the IR receiver connected to
IR
ALL IN
port of the matrix is with IR carrier,
can the received IR signal be transferred to the IR OUT port of the matrix.
If the IR receiver connected with the HDBaseT receiver or IR ALL IN port of the
matrix is not with IR carrier, send the command
“%0901.” to enter infrared carrier
enforcing mode, and then the IR signal can be transferred to the IR OUT port.
5.2.3 Controlling a Far-end Device from the Matrix
Connect an IR receiver to the IR IN/IR ALL IN port on the switcher, and use the IR
Remote of the far-end device to control the device locally.
1 to 1: (through IR IN)
Connect an IR receiver with IR carrier to the IR IN port of the 4K HDBaseT 4x4
Matrix Switcher, users can control a far-end output display via its IR remote from the
Matrix location.
In this case, the IR signal is transferred via the twisted pair. Only the corresponding
IR OUT port can emit control signals to the remote display.
See the figure below:
Note: The IR receiver connected to
IR IN
must contain IR carrier
1 to All: (through IR ALL IN)
Connect an IR receiver to the IR ALL IN port of the 4K HDBaseT 4x4 Matrix
Switcher, the IR signal received from the IR ALL IN port will be transmitted to all the
4 connected far-end HDBT receivers. See as below:
PoC
Receiver
DVD
HDTV
IR Remote
HDTV
IR Emitter
Summary of Contents for AVG-UHMS44PRO
Page 35: ...AVG UHMS44PRO 7 Panel Drawing ...
