AVG-DSS61
4. System Operations
4.1. Front Panel Button Control
Front panel buttons can be used for source selections, output resolution adjustment,
front panel button management, software updating and output resolution selection.
(Please refer to chapter 2.1).
There are 6 sources to choose from in total, including HDMI1, HDMI2, HDMI3,
HDMI4, VGA1, VGA2. Video signals support auto-switching and manual-switching
(factory default). Press and hold the SOURCE/AUTO button for 3 seconds or more
to enter auto-switching/ manual-switching mode.
Manual-switching:
Press
◀
to select the previous source, dial
▶
to select the next source.
Auto-switching:
In this mode, selecting the input source via front panel button (
◀
▶
) is not available,
however, RS232 command and IR remote are able to switch mode. The auto LED
turns green and stays on.
The auto-switching mode uses the following principles:
New input principle
Once detecting a new input signal, AVG-DSS61 will switch to this new signal
automatically.
Rebooting device principle
AVG-DSS61 have the ability of power-off memory. If the last switching mode is
auto-switching, once rebooted, AVG-DSS61 will automatically enter auto-
switching mode, and then detect all inputs and memorize their connection status
for future rebooting using. If the last displayed signal is still available, AVG-
DSS61 will output the signal. If not, the unit will detect all the inputs signals with
priority from HDMI1 to VGA2. When detected the first signal, it will transfer to
output.
Signal removing principle
Once removing the current display signal, AVG-DSS61 will detect all input signals
with priority from HDMI1 to VGA2. It will transfer the signal firstly detected to be
available to output devices
