56
ZM303 Indicator User Instructions
Supervisor menu
7.2.1 Accumulator
Super
Setpoint
Tare
Accum
1.
With the Accumulator application active, access the Supervisor menu using
password 1793. Refer to
Accessing the menus on page 34
for instructions.
From
SuPEr
, press
SELECT
…
SEtPnt
is displayed.
2.
Press
UNITS
until …
AccuM
is displayed. Use this to set the items relating to accumulation.
Under
AccuM
you can do the following:
l
Enable/Disable the ability to print the accumulated total (
Prt tot
).
l
Key in a print format number for printing the total accumulated weight
information (
tot FMt
).
l
Enable/Disable the ability to clear the total accumulation information
when the total is printed (
clr tot
).
l
Print the accumulation report for all 10 memory channels (
).
l
Reset all 10 accumulator memory channel values to 0 (
rESEt
).
The following steps describe the procedure to set these items.
Print total
Accum
Print Total
3.
From
AccuM
, press
SELECT
…
Prt tot
is displayed. This stands for print total.
4.
Press
SELECT
…
oFF
is displayed.
5.
Press
ZERO
to keep the print total function disabled or press
UNITS
to toggle
to
on
and press
ZERO
to enable printing of the accumulated total …
Prt tot
is displayed.
If enabled, during normal operation the user can press and hold
for three seconds and the selected total print format (see step
below)
will be sent out any port that is set up to printed. The display will flash
Prn-tot
.
Total format
Accum
Print Total
Total Format
6.
Press
UNITS
…
tot FMt
is displayed. This stands for the total print format.
7.
Press
SELECT
…
The current print format number is displayed with a flashing right-most
digit. (Default is format 8)
