ZK810 Counting Scale User Instructions
11
2.3 Powering up the ZK810
2.2.1 Annunciators
The annunciators on the display are shown and labeled in
Figure 2.2
.
Figure 2.2 Annunciators
The triangular annunciators will light during operation to inform the user of the weighing
mode, active unit of measure, etc.
2.3 Powering up the ZK810
The ZK810/BSQ comes with a base mounted AC power supply unit (PSU) connected
to the back of the BSQ. This supplies the required input power of 12 to 36 VDC @
250ma minimum and is connected to a properly grounded outlet (100 VAC - 240 VAC,
50 or 60 Hz). The indicator is always ON as long as power is received. See
Base
mounted AC PSU
on page 13
.
If using the optional rechargeable battery pack mounted on the rear of the base you
can expect approximately 20 hours of operation between charges. Recharge time is
four hours using the in-line PSU. The battery pack requires 24 to 36V to charge. See
Battery power
on page 14
for more information. The battery timer setting can be used
to turn the indicator display OFF automatically.
You can also power the indicator with a 12 to 36 VDC power supply (250ma minimum
at 24VDC) via a 2.1mm center positive barrel jack plugged into the receiver on the back
of the indicator.
The first time you power up the ZK810 you need to pick which application you will be
using. See
First time power up
on page 16
for instructions on how to do this.
kg
GROSS
NET
TARE
0
g
COUNT
Center-of-zero
Motion
Gross weight
Net weight
Tare weight
Units of
measure
Count
Network
connection
Piece
Weight
