31
Indicator Diagnostics
The test mode is used to test various functions of the WI-125. The test
menu is shown in Figure 12. Instructions for using the test menu are found
below.
Figure 12
Test Menu
1.
Enter the test mode from gross/net operation by pressing and holding
the MENU key until
tESt is displayed. SEALEd or unSEALEd is dis-
played briefly while you hold the key.
2.
Move to the right through the menu selections by pressing MENU
briefly. Move to the left through the menu selections by pressing MENU
for 1 second or hold down for continuous scrolling.
3.
To move down a level in the hierarchy, press SELECT. Anytime you
wish to get to the next higher level in the hierarchy, press and hold
SELECT for approximately 1.5 seconds or press SELECT whenever
End is displayed.
4.
Press MENU to toggle between choices.
5.
Press G/N to return to gross weighing operation at any time.
Summary of Contents for QTLTSC
