40
User’s Manual—SNAP™ 500 Gen 1 and Gen 2
Classification: Avery Dennison - Public
4.3.6 Clearing Print Jobs
If you have sent print jobs to the printer and do not want to print the labels, press
and hold both the Start/Stop and Voice buttons simultaneously. After about 2
seconds, the printer will say “Clearing Current Batch.” If there is only one print
job, the Data light will go out.
If there is more than one print job and you only want to clear the current one,
release the buttons.
If there are more than one print job and you want to clear them all, continue to
hold the buttons until the printer says, “Clearing All Batches.”
4.4 Using Pre-printed Stock
When using pre-printed stock, the printer must detect a sense mark on the tape
in order to print in the proper place.
The SNAP 500 printer comes with a top reflective sensor standard. This
sensor, mounted in the top-right-hand post of the web guide, detects a
black sense mark on the top surface of a white tape. The sensor cannot
be moved from the center position.
A contrast sensor option will detect a colored sense mark on the top
surface of a colored tape. Mounted on the left-hand post that holds the
web guide. It is movable across the web. See Appendix 10.5.
A hole sensor is an option. This sensor will detect a hole or slot either
centered on the stock or ¼” from the inboard edge of the stock. See
Appendix 10.6
4.4.1 Selecting the Sensor
The registration sensor type can be selected in one of two ways. First, the
sensor type can be selected as part of the format (see the PCMate Platinum
manual or the PCL manual for details).
The sensor type that is selected in the format can be overridden using the Virtual
Control Panel.
The printer does not know if the optional hole or contrast
sensor is installed. If one of these sensors is selected but
not installed, the printer will not operate properly.
4.4.2 Aligning the Stock to the Sensor
In order to work properly, the stock must be aligned to the sensor before starting
to print. To do this, open the print-head rollers and use the Feed knob until the
sense mark is just to the left of the sensor. Then rotate the rewind ink arbors to