Avery Dennison Monarch ADTP1, System Administrator Manual

Page: 52 / 94

7-2
System Administrator’s Guide
Classification: Avery Dennison - Public
Do w n l o ad in g a S cr ip t
Follow these instructions to download a script from the command prompt. Set the
communication parameters using the MODE command. Then, prepare the printer to
accept a script. Select Load Script from the printer’s menu:
Select To
No Keeps the existing script (if one is loaded).
The printer is not ready to accept a script file.
Yes Deletes the existing script on the printer.
Prepares the printer to accept a new script file.
Note: Only one script can be loaded in the printer at a time.
Send the script file to the printer.
When downloading a script, if you receive an error:
♦
Check the available flash memory. See " Viewing Available Flash Memory " in
Chapter 6 for more information.
♦
Format flash memory. See " Formatting Flash Memory " in Chapter 6 for more
information.
After downloading a script, if the script does not appear to be loaded, try formatting flash
memory and download the script again.
E n ab l in g a S cr ip t
The script must be enabled before you can use it.
Select To
No Does not enable the script. (Stop the script).
Yes Start the script. When you turn the printer off and back on, the
script automatically starts.
When you see “Ready,” the word “Script” appears in the upper
left-hand corner of the display.
When a script is not loaded, this message appears:
D el e t i n g a S cr i p t
You can delete a script from the printer's memory.
Select To
No Does not delete the script.
Yes Deletes the script.
The flash memory used by the script is not available for other scripts or fonts until the
flash memory is reformatted. However, when you format flash memory, you must resend
the script and any downloaded fonts to the printer.