TC9415MOI Rev. AA 2/08
©2008 Avery Dennison Corp. All Rights Reserved.
M A I N T E N A N C E I N S T R U C T I O N S
Use these instructions to clear label jams in your Monarch® 9415™ Food Freshness System.
Caution:
These instructions are for
managers only
. Removing the platen roller could void
your warranty.
Do not
use sharp objects to remove jammed labels from the supply slot or the
platen roller. This damages the roller and voids the warranty.
R e m o v i n g t h e P l a t e n R o l l e r
1.
Turn off the printer.
2.
Lift the printer from the wall and place it on a table or other flat surface.
3.
Tear off any labels in the supply slot, then open the supply door and remove the roll of
labels. Do not pull labels backwards through the supply slot. This causes jams.
4.
Remove the supply holder guides from the supply holder.
5.
Use a Phillips screwdriver to remove the four screws from the printhead cover.
6.
Lay the printhead cover to the side. Do not detach the sensor cable.
7.
Carefully lift the print module and rotate it toward you so the platen roller faces up.
Be careful not damage or remove the flex cables.
Printhead Cover
Supply Holder Guide
Sensor Cable
Flex Cables
Print Module
