2-2
Operating Instructions
B a t t er y L i f e
The MW S Battery Status LEDs are located on the top-left side of the Power Panel. To use the
Battery Status LEDs, the MW S must be on.
If you leave the battery charger plugged in and constantly charging
when the MWS is not in
use (turn MWS power off)
, the battery life is maximized for the application. The charger does
not overcharge the batteries.
The MW S has signal lights to indicate the battery status as follows. The following voltages are
an approximation and should be used for reference only.
Flashing Orange
Warning! The batteries need immediate charging. The MW S beeps
continuously to alert you of this condition. (Early models have red lights
instead of orange).
Flashing Yellow
Caution! Finish printing the batch, then recharge the MW S. The batteries
are getting low.
Flashing Green
Go! The batteries are charged to approximately 75% or better capacity.
If the CHARGE light does not turn on, make sure the charger is properly connected to the
batteries and the charger has AC power.
If the READY light does not turn on after 18 hours, the batteries are deeply discharged. Call
Technical Support or replace the batteries.
A b o u t t h e B a t t e ry Ch a rg e r
♦
Store the charger in a dry area not subject to prolonged below freezing temperatures.
♦
The “intelligent” battery charger monitors the batteries condition and does not overcharge
the batteries. It is recommended to leave the battery charger plugged in and charging
when the MW S is not in use. Battery life is extended by frequent charging.
♦
The charger’s Green light is on when the battery is finished charging. Leaving the charger
plugged in prevents the battery from self-discharging.
♦
The MW S Battery Status LEDs provide the most accurate indication of battery status. While
the 24VDC charger has Percentage LEDS that also show battery status, use the three
Battery Status LEDS on the Power Panel.
MW S P ow er Sw i tch