6
The green power LED on the 6054 Network Control
Module turns on when there is power to it.
Charging time can take up to three hours. It takes
approximately 1 hour to reach the 80% level (where it is
now usable). To reach 100%, it takes approximately 2
hours more.
Reading the Display
Charging LED – flashes when you insert the printer;
on (solid) during charging; off when charging is
complete.
Complete LED – flashes when the printer’s battery is
80% charged; on (solid) when the battery is 100%
charged.
Note:
The Charging and Complete LEDs are ON
continuously when updating the printer’s
firmware while on the Docking Module.
Do not
remove the printer or disconnect power to the
Docking Module at this time.
T r o u b l e s h o o t i n g
When an error occurs, the Charging and Complete LEDs
blink together. In this case, repeat the charging process.
If the error still occurs, put a new battery into the printer
and place the printer back into the charger. If there is a
problem after the second attempt to charge, call Service.
In between charges, remove the printer, wait for the
lights to stop flashing, then re-insert the printer.
If you experience communication problems while
charging, check the Ethernet LEDs. See “Reading the
Ethernet LEDs” for more information.
Summary of Contents for 6055
Page 8: ...8...
