d) Switch on the projector with “Power ON” button located at the projector body or it’s remote transmiter.
e) LED1 indicator will blink 3 times and douse to confirm the power consumption level was recognized and
memorized.
Beta control system is ready for usa as soon as the programming procedure is finished.
4. Control system operation
4.1 Automatic operation
- Press “POWER” button at the projector’s remote control transmitter or at the projector itself, projector lamp will light-
on. BETA control system will switch on motors of connected devices (i.e. projection screen and projector lift).
Motors will stop automatically as soon as the bottom stop points will be reached.
- Press “POWER” button at the projector’s remote control transmitter or at the projector itself, projector lamp will light
off. BETA control system will switch on motors of connected devices (i.e. projection screen and projector lift). Motors
will stop automatically as soon as the upper stop points will be reached.
4.2 Manual operation
Manual control of devices conected to the BETA control system is possible with the optional wall control switch (original
screen/lift wall control switch) connected to the dedicated termina.
- Push button “
‚
”, BETA control system will switch on motors of connected devices (i.e. projection screen and
projector lift). Motors will stop automatically as soon as the bottom stop points will be reached.
- Push button “
”, BETA control system will switch on motors of connected devices (i.e. projection screen and
projector lift). Motors will stop automatically as soon as the upper stop points will be reached.
4.2 Control system maintenance
BETA control system do not require periodical service maintenance. Clean dust from the control unit case with dry soft
cloths. If needed use moisturized cloth with soft detergent to remove stains. After stain removal dry the cleaned surface
with cloth carefully.
4.3 Before calling the service
!!!CAUTION!!!
Programming procedure must be performed each time attached projector is replaced with an other unit/model
Avers BETA control system provides automatic and/or manual control of 2 electric devices for example Avers projection
screen (models without integrated control system) and Avers Prolift projector lift.
At other cases please contact service.
Symptoms
Reasons
Remedy
Control system do not react to
projector “Power On” action
Projector power cord is not plugged into the
BETA power outlet.
Power consumption from the outlet at the
Trigger Transmitter is too low.
Plug in projector power cable to the BETA
power outlet.
Re-programm BETA control system with the
projector.
