www.avenview.com
Page 7
4.
INSTAllATIoN (W-HD3D
IR
-50m)
To setup Avenview W-HD3D
IR
-50m please follow these steps for connecting to a device:
1. place the Transmitter unit in close proximity to the HDmI source device.
2. Connect the HDmI source device to HDmI IN port of the Transmitter by using a standard HDmI cable.
3. Connect the IR Extension cable to the port on the transmitter unit.
4. place the other end of the IR Extension cable near the IR port on the HDmI source device.
5. place the Receiver unit near your HDmI display/projector, Connect the HDmI display /projector to the HDmI output
port of the Receiver unit.
6. Connect the power adapter (included) to the DC IN ports of the Transmitter and Receiver.
once these steps have been completed the Extender is ready to use, simply power on all devices to begin operation.
once all equipments are powered on, it is shown by the blue link lED (refer to table below). Then system will initiate a wireless
link, successful connection of the link will be shown by the
Amber
link lED (refer to table below). This may take short
time depending on the distance between the units and other environmental factors.
When the initial wireless link has been established, the system will establish a video link between the transmitter and
receiver. once it has been completed, the
green
video
lED will be lit on both units. If your HDmI source and display
devices support CEC then your source device can simply
be
control
led
using the display
'
s remote control.
LED STATUS
Description
lED
Steady Blue
(Tx, Rx)
power on
lED
Slow
Blink
Amber
(Tx, Rx)
Establishing
video
link
lED
Fast Blink
Amber
(Tx, Rx)
Established
video
link
lED Steady
Green
(Tx, Rx)
Established
TX/RX
link
