www.avenview.com
12
1.9
Installation (SW-HDMI-C5-4X4)
To setup Avenview SW-HDMI-C5-4X4 follow these steps for connecting to a device:
1.
Connect all sources to HDMI Inputs on the 4X4 HDMI over CAT5 Matrix Switch (SW-HDMI-C5-4X4)
2.
Connect each DDC output on the SW-HDMI-C5-4X4 to respective DDC input on the remote receiver
HDMI-C5SW-R
3.
Connect each TMDS output on the SW-HDMI-C5-4X4 to respective TMDS input on the remote
receiver HDMI-C5SW-R
4.
Connect IR emitter cable to the SW-HDMI-C5-4X4 and direct the IR emitter to the build-in IR receiver
of the sources
5.
Connect the +5V 6A DC power supply to the SW-HDMI-C5-4X4
6.
Power on all HDMI sources
7.
Power on the SW-HDMI-C5-4X4
1.10
Operation and IR Control
1.10.1 Source Side
1.10.1.1Method A: Push Button
Push the switch button on the front panel, the source will be sequentially changed.
(+) increase
(–) decrease
1.10.1.2Method B: IR Remote Control
a.
Please press F1 to F6, Enter (
), and Exit (
) button to enter IR control mode and decide which
output port to be controlled (see the table below), and wait a few seconds for the output port LED
to show the number of selected output port. Or you can use up (
) and down (
) button to enter
IR control mode and select the output port in ascending and descending order respectively. Decide
which output port to be controlled by pressing F1 to F4, and wait a few seconds for audio/video of
next channel coming out after the channel switch command is sent.
Summary of Contents for 8X8 HDMI 1.3 over CAT5Matrix Switch with IR Pass-Through
Page 5: ...www avenview com 5...
