© Copyright 2008, Aventura Technologies, Inc.
3
POWER CONNECTION
Power is supplied to the unit via a two-pin terminal block connector. Follow the labeling on the unit for
proper connections of the +12 volt dc and ground leads.
ETHERNET CONNECTION
The UTP Ethernet connection is made via an RJ-45 connector on the front of the unit. For proper
operation, the use of a patch cord and/or cable rated Category-5 or better is required.
FIBER CONNECTION
The fiber optic connections vary, depending on the selection of SFP module. Refer to the instructions
supplied with the SFP module for the proper procedure of installing the SFP module in the
FBR-
1FE1FX-SFP
unit, as well as for the proper procedure for connecting the fiber to the SFP module.
STATUS INDICATORS
Each unit provides the following LED status indicators to aid in installation and troubleshooting:
POWER INDICATOR
A bi-color LED indicator monitors the voltage at the unit’s input connector and the operating internal
voltage of the module. The power status associated with this indicator is summarized below.
Power Indicator
Power Status
Green
Proper Input Voltage Present – Proper Internal Operating Voltage Present
Red
Proper Input Voltage Present – Internal Operating Voltage Faulty
Off
No Input Voltage Detected
OPTICAL LINK INDICATOR
A bi-color LED indicator monitors the power of, and proper synchronization with the optical input
signal that is being received at the
FBR-1FE1FX-SFP
. The optical link status associated with this
indicator is summarized below.
Optical Link Indicator
Optical Status
Green
Proper Optical Input Present
Red
Optical Input Not Detected
Off
Check Power Supply
ETHERNET INDICATORS
Two LED indicators on the RJ-45 connector of the
FBR-1FE1FX-SFP
unit monitor the status and
operating mode of the UTP Ethernet link. The Ethernet status associated with these indicators is
summarized below.
Ethernet Indicators
Ethernet Status
Speed
(GREEN)
Lit:
Link operating at 100Mbps
Unlit:
link operating at 10Mbps or no link
Link/Activity
(GREEN)
Lit:
Good link on the port
Blinking:
The port is receiving/transmitting data
Unlit:
No link
