16
Mount the clip-on front panel on the support.
Mount the front panel on the support by pressing deeply into all its surface. All front panel locks
must be
fi
xed. It is suggested to mount and remove the front panel with the video door phone
NOT powered. Otherwise, temporary malfunction of touch buttons could occur.
Remove the protection
fi
lm.
1.1
TERMINAL PINS DESCRIPTION
BUS IN
Connection to the system BUS
BUS OUT
Connection to the next device for an in/out connection
S+
Call
repeat
S-
Call
repeat
P
Floor
call
BUS AVE +
Connection to BUS AVE +
BUS AVE -
Connection to BUS AVE -
1.2
CONFIGURATION OF APARTMENT STATIONS BRACKETS
=
=
ON
ON
Default values
:
all video door phones default con
fi
guration is the following:
USER = 127
INTERNAL CODE = 0
Therefore, for the proper operation of the system,
always pay attention to dip switches, in order to
con
fi
gure them with the correct value
.
For dip switch settings, see the system manual provided with the power supply Ref. 1083/20.
CODE
: user code.
Set a number from 0 to 127, according to the following rules:
In the column there must not be any apartments with the same user code.
If there are apartment stations in parallel in the same apartment, these must have the same user
code.
The user codes of the same column must be consecutive.
To set the desired code, use the dip switches from 2 to 8 (2= most signi
fi
cant bit - 8= less
signi
fi
cant bit); the dip-switch 1 must be set to OFF.
•
•
•
LBT AVE.indd Sez116
LBT AVE.indd Sez116
28-09-2010 16:46:17
28-09-2010 16:46:17
