- 27 -
G
Function 3:
setting, display and modification of the USER CODE
Note 3:
The code programmed at the factory is
0000.
It is possible to change and enter the user
code by means of the above-mentioned procedure. If the user looses or forgets his own
code, he should proceed as follows:
• Cut the mains voltage and disconnect the back-up battery and the GSM battery
• Connect the mains voltage, the back-up battery or the GSM battery again
The device now allows the user to enter the programming with the factory code (0000) within a
period of 30 s. and to modify the previously programmed code.
Warning
If this operation is not performed within 30 sec., the dialler returns to the condition in which it
accepts only the previously programmed user code.
FUNZIONI
FUNZIONI
FUNCTIONS
programming.
Entering of
FUNCTION 3:
setting, display and
modification of the USER CODE.
COD UT
COD UT
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
3
✗
✓
✗
Display of the USER CODE previously program-
med for confirmation (see note 3)
To change it, keystroke the new USER CODE
(min. 4 figures)
1 2 3 4
1 2 3 4
✗
✓
✓
Confirmation of the programmed
USER CODE or exit from the function by
time-out or number re-entering through key
✗
C.410 7-06-2002 16:43 Pagina 27
