Avaya T3 Comfort, Service Manual

Page: 44 / 73

Menus of the IP telephone
44
Switching functionality and VLAN-configuration
It is possible to configure the switch using:
•
the user interface (Audit menu) in functional mode
•
the Web terminal
•
the Admin tool
The following switch parameters can be configured:
•
Speed for LAN and PC port (10/100 Mbit and automatic)
•
Duplex for LAN and PC port (half, full and automatic)
•
Interport VLAN configuration
Up to four VLANs can be configured. Configuration is possible using:
•
the user interface (Audit menu) in functional mode
•
the Web terminal
•
the Admin tool
The following VLAN parameters can be configured:
•
VLAN ID for max. of four VLANs
•
VLAN assignment to port
•
Specify or change priority of frames (IEEE 802.1p) to the LAN and PC port.
The integrated switch is part of the controller chip being used. It is not possible to reset
the IP telephone and switch separately. Inter-switch protocols, such as CISCO’s
proprietary protocol, are not supported.
To ensure that the VLAN settings in the IP telephone network are functioning, all the
connected network components have to support VLAN functionality and be configured
accordingly. The connected PC does
not
require a specific configuration.
Note:
•
Cascading (i.e., connecting one IP telephone to the PC port of another IP
telephone) is not supported!
•
An IP telephone reset disrupts the existing IP connections of a connected PC.
•
If you press and hold the “OK” key when connecting the IP telephone to the
power supply, the telephone immediately jumps to the configuration settings of
the VLAN (after requesting the audit password).