1
Power down the system before inserting or removing a PC Card.
A) If you have a Stand-alone or 2-Slot Carrier, unplug the power cord from the wall outlet and disconnect the
power cord from the power jack on the carrier.
B) If you have a 5-Slot Carrier, move the carrier’s On/Off switch to Off (“O”) and unplug the power cord from
the wall outlet.
2
If you do not have a 5-slot carrier, go to Step 3.
If you have a 5-slot carrier and a system of Release 4.0 or later, perform the following steps to remove the
carrier’s cover:
A) Loosen the thumb screw at the bottom of the carrier cover.
B) Rotate the carrier cover to disengage the tabs at the top of the modules from the openings on the top of
the carrier cover.
If you have a 5-slot carrier and a system of Release 3.0 or earlier, perform the following steps to remove the
carrier’s cover:
A) Loosen the screw on the lower front of the cover.
B) Place one hand on the handle on the bottom front of the cover, and place your other hand on the top of
the cover. Gently pull the cover up and away from the carrier—be careful not to break the tabs that attach
the cover to the carrier.
3
If your card comes with a write-protect tab, verify that the
write-protect tab on the PC Card is not in the write-protected
position. If it is, use a paperclip or another pointed object to push the
write-protect tab on the end of the PC Card upward to the
nonprotected position.
If your new PC Card is a Software Upgrade Card, or if you are
using your PARTNER Remote Access PC Card to upgrade your
processor, remove all other PC Card(s) from the PC Card slot(s)
on the processor module by gently pulling each card straight
out (with the power off).
Stand-alone
Processor Module
2-Slot Carrier
5-Slot Carrier
On/Off Switch
Power
Jack
PARTNER
3000
PARTNER
3000
PARTNER
3000
PARTNER
3000
PARTNER
3000
