QUICK START GUIDE
QUICK START GUIDE
1. Solder a high quality battery connector to the ESC.
2. Mount the ESC and motor into the car.
3. Connect the 3 motor wires in to the ESC.
4. Connect the ESC Rx lead to CH2 on your receiver.
5. Make sure the ESC’s switch is off.
6. Connect a battery.
7. Calibrate your ESC to your radio by holding full throttle on
your transmitter then turn the switch ON.
8. After a few seconds you’ll hear multiple tones and the red
LED will come on.
9. Now hold full brake and after a few seconds you’ll hear
multiple tones and the yellow LED will come on.
10. Now relax to neutral and after a few seconds you’ll hear
multiple tones and ALL the LEDs will light up.
11. A few seconds later the ESC will arm with a double tone and
you’re ready to go!
Revised 03/2017
Cop
yri
ght 2
017 © C
ast
le C
rea
tio
ns, I
nc.
PKG: 057-0206-03
