12
Initializing the Avaya CallPilot® Mini
P1002915 01.1
Changing the IP address using an Ethernet crossover cable
Using an Ethernet crossover cable, you can connect the Avaya CallPilot® Mini to your computer.
With this connection, you can use CallPilot Manager to change the Avaya CallPilot® Mini IP
address before you connect it to the network.
To use an Ethernet crossover cable, your computer must be equipped with a 10/100 BaseT
Ethernet card and support TCP/IP protocol.
Connecting the Ethernet crossover cable
1
Shut down the computer.
2
Attach one end of the Ethernet crossover cable to the Ethernet port on the Avaya CallPilot®
Mini.
3
Connect the other end of the cable to the network interface card on your computer.
4
Start the computer.
5
Use the Quick Install Wizard to initialize the Avaya CallPilot® Mini.
For information about how to use the Quick Install Wizard, refer to
.
Running the Quick Install Wizard
The Quick Install Wizard appears the first time you startup CallPilot Manager. The Quick Install
Wizard is a single page that gathers enough information to set up a working system. It then applies
the information and restarts the system.
You can reach CallPilot Manager from another computer through a LAN connection, WAN/
Internet connection or an Ethernet crossover cable. All of these methods create an IP connection
that allows you to run CallPilot Manager.
Use the following procedure to run the Quick Install Wizard:
1
Launch your browser.
2
In the URL address box, type the Avaya CallPilot® Mini IP address.
For example:
HTTP://192.168.110.10
Note:
If you do not have access to the Avaya CallPilot® Mini through the network, you
can use an Ethernet crossover cable to configure all of the Avaya CallPilot® Mini
parameters.
Note:
You must include
HTTP://
to access CallPilot Manager.
